Huawei SmartAX MA5603T Configuration Manual page 329

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Item
VoIP user data
(The data
configuration
must be the
same as the data
Issue 01 (2014-04-30)
Transmission
mode of the MG
interface
Domain name of
the MG interface
Digitmap of the MG interface
Software parameters of the MG
interface
Ringing mode of the MG
interface
Terminal ID (TID) format of the
MG interface
Slot for the voice service board
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Configuring the DSLAM Services
Data
UDP is adopted.
The message ID (MID) adopts the IP
address (default), and may not be
configured with the domain name.
Special applications such as emergency
calls and emergency standalone are not
configured, and therefore the digitmap
is not configured here.
According to the Background
Information in (Optional) Configuring
the Software Parameters of an MG
Interface and confirmed with the
service provider, the default settings
can meet the service requirements.
Therefore, the software parameters are
not configured here.
Confirmed with the service provider,
the value of the ringing parameter
(corresponding to the users) defined on
the MGC is 0 (value of mgcpara), and
the users have no special requirements
for the ringing mode. Therefore, the
normal ringing with the break-make
ratio of 1:4 is adopted.
To differentiate users according to the
TID, the service provider requires that
the terminal prefix uses the community
name huawei and the TID is
automatically generated by the system
according to the slot ID/subrack ID/port
ID of the user.
Run the display tid-template
command to query the default TID
template. It is found that default TID
template (template 6) can meet the
requirements.
User access is implemented by the
ASPB board in slot 0/3.
304