Huawei SmartAX MA5603T Configuration Manual page 936

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Add an MG interface to communicate with the MGC, which ensures that the MGC can control
the call connection through the MG interface. Add MG interface 0 according to the data plan.
huawei(config)#interface h248 0
Are you sure to add MG interface?(y/n)[n]:y
Step 6 Configure the attributes of the MG interface.
Pay attention to the following when configuring the attributes of the MG interface according to
the data plan:
l The MG interface is registered by the IP address (default mode) or domain name, which must
be the same as that on the MGC.
l The negotiated H.248 protocol version is V1, V2 or V3 (default value). The interface may
fail to be registered because some softswitches do not support V3.
huawei(config-if-h248-0)#if-h248 attribute mgip 10.10.10.10 mgport
2944 code text transfer udp primary-mgc-ip1 200.200.200.200 primary-mgc-port
2944 mg-media-ip1 10.10.10.10 start-negotiate-version 1
Step 7 Reset the MG interface.
huawei(config-if-h248-0)#reset coldstart
Are you sure to reset MG interface?(y/n)[n]:y
huawei(config-if-h248-0)#quit
NOTE
l You must cold reset the MG interface after configuring. Otherwise, the MG interface does not take effect.
l The MG interface can be cold reset only after parameters mgip, mgport, primary-mgc-ip1 (or mgc-domain-
name1), mgcport_1, code, transfer, and mg-media-ip are correctly configured.
Step 8 Configure the PSTN user data.
Configure phone numbers of users 0/3/0-0/3/23 to 83110001-83110024 in batches and terminal
identification to 0.
l Phone numbers are used for only internal emergency standalone, that is, internal extensions
call each other. Actual phone numbers are assigned by the MGC.
l If the user of the MG interface is configured to support terminal layering, you need not
configure the terminal identification because the system automatically allocates it. If the user
of the MG interface does not support terminal layering, the terminal identification is
mandatory. The terminal identification must be unique on one MG interface.
huawei(config)#esl user
huawei(config-esl-user)#mgpstnuser batadd 0/3/0 0/3/23 0 terminalid 0 telno
83110001
Step 9 Configure the call priority of a PSTN user.
huawei(config-esl-user)#mgpstnuser modify 0/3/0 priority cat2
huawei(config-esl-user)#quit
Step 10 Configure all the PSTN ports to support polarity reversal.
Configure the physical attributes of the PSTN port to which the users belong to support polarity
reversal so that the user supports polarity reversal accounting.
huawei(config)#pstnport
huawei(config-pstnport)#pstnport attribute batset 0/3/0 0/3/23 reverse-pole-pulse
enable
huawei(config-pstnport)#quit
Step 11 Save the data.
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
11 FTTB and FTTC Solution Configuration
911