Huawei SmartAX MA5603T Configuration Manual page 965

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Table 11-21 Key information about the Internet access service (VDSL2 access)
Item
Traffic profile
VDSL2 line
mode
VDSL2 line
template
VDSL2 alarm
template
Procedure
Step 1 Log in to the ONU to perform the configuration.
You can remote log in to the ONU from the OLT to perform the configuration. User name:
root (default). Password: mduadmin (default).
Step 2 Configure a traffic profile.
You can run the display traffic table ip command to query the traffic profiles existing in the
system. If the traffic profiles existing in the system do not meet the requirements, you need to
run the traffic table ip command to add a traffic profile.
Add traffic profile 8 and set the committed information rate (CIR) to 4 Mbit/s. The priority for
upstream packets is 0, and downstream packets are scheduled based on the priority specified in
the traffic profile.
Issue 01 (2014-04-30)
Data
ID: 8
CIR: 4 Mbit/s
VLAN priority: 0
Downstream priority policy:
local-setting
PTM
Line profile ID: 1 (default)
Channel profile ID: 1 (default)
Line template ID: 1 (default)
Line alarm profile ID: 1 (default) The system does not check whether
Channel alarm profile ID: 1
(default)
Alarm template ID: 1 (default)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
11 FTTB and FTTC Solution Configuration
Remarks
A traffic profile implements rate-
limiting.
There are two VDSL line modes: ATM
mode and PTM mode.
l ATM mode: ATM cells are
transmitted in channels. This mode
is compatible with the ADSL2+
mode.
l PTM mode: IP cells are transmitted
in channels. This mode is
incompatible with the ADSL2+
mode.
This example assumes the PTM mode.
A traffic profile or a VDSL2 line
template can implement rate-limiting
on VDSL2 ports. This example uses a
default traffic profile.
parameter thresholds are crossed and so
does not report alarms.
940