Huawei SmartAX MA5603T Configuration Manual page 643

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Issue 01 (2014-04-30)
huawei(config-gpon-lineprofile-1)#commit
huawei(config-gpon-lineprofile-1)#quit
3. Configure the VLAN of the Ethernet port on the ONT.
If the ONT is connected to the STB through Ethernet port 2, add Ethernet port 2 to
VLAN 1000.
huawei(config)#ont-srvprofile gpon profile-name ftth
huawei(config-gpon-srvprofile-1)#port vlan eth 2 1000
huawei(config-gpon-srvprofile-1)#multicast-forward untag
huawei(config-gpon-srvprofile-1)#commit
huawei(config-gpon-srvprofile-1)#quit
4. Configure the native VLAN of the ONT port.
If the ONT is connected to the STB through Ethernet port 2, the native VLAN ID is
1000.
huawei(config)#interface gpon 0/1
huawei(config-if-gpon-0/1)#ont port native-vlan 0 1 eth 2 vlan 1000
huawei(config-if-gpon-0/1)#ont port native-vlan 0 2 eth 2 vlan 1000
huawei(config-if-gpon-0/1)#quit
5. Create a service VLAN and add an upstream port to it.
Add upstream port 0/19/0 to VLAN 1000.
huawei(config)#vlan 1000 smart
huawei(config)#port vlan 1000 0/19 0
6. Create service flows.
Set the service VLAN to 1000, GEM port ID to 13, and user VLAN to 1000, and use
traffic profile 8.
huawei(config)#service-port 1 vlan 1000 gpon 0/1/0 ont 1 gemport 13 multi-
service
user-vlan 1000 rx-cttr 8 tx-cttr 8
huawei(config)#service-port 2 vlan 1000 gpon 0/1/0 ont 2 gemport 13 multi-
service
user-vlan 1000 rx-cttr 8 tx-cttr 8
7. Create an MVLAN and configure the IGMP version.
Set the IGMP version for the MVLAN to IGMPv2.
huawei(config)#multicast-vlan 1000
huawei(config-mvlan1000)#igmp version v2
This operation will delete all IPv4 programs with source IP addresses in
the
current multicast VLAN
Are you sure to change current IGMP version? (y/n)[n]:y
Command is being executed. Please wait...
Command has been executed successfully
8. Configure a program library.
Set the mode for obtaining multicast programs to dynamic.
NOTE
You can set the mode for obtaining multicast programs to dynamic only when the IGMP mode is
off.
huawei(config-mvlan1000)#igmp mode off
Are you sure to close IGMP? (y/n)[n]:y
Command is being executed. Please wait...
Command has been executed successfully
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 FTTH Configuration
618