Huawei SmartAX MA5603T Configuration Manual page 310

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
2.
3.
4.
5.
Step 7 Save the data.
huawei(config)#save
----End
Verification
The procedure for triggering the 802.1X client by DHCP in the Windows XP OS is as follows:
l
l
l
l
l
Issue 01 (2014-04-30)
Configure an 802.1X parameters. In the local termination authentication, the 802.1X
parameters should be configured to be in the EAP termination mode. The count of allowed
handshake failure is 1 and the handshake interval is 20s.
huawei(config)#dot1x keepalive retransmit 1 interval 20 service-port 1
huawei(config)#dot1x keepalive retransmit 1 interval 20 service-port 2
huawei(config)#dot1x keepalive retransmit 1 interval 20 service-port 3
huawei(config)#dot1x eap-end service-port 1
huawei(config)#dot1x eap-end service-port 2
huawei(config)#dot1x eap-end service-port 3
Name the AAA authentication scheme huawei and name the AAA accounting scheme
huawei. During the local authentication, the AAA authentication scheme is a local
authentication. Therefore, you do not need to configure the RADIUS server profile;
however, you need to configure the accounting mode in the accounting scheme to none.
huawei(config)#aaa
huawei(config-aaa)#authentication-scheme huawei
huawei(config-aaa-authen-huawei)#authentication-mode local
huawei(config-aaa-authen-huawei)#quit
huawei(config-aaa)#accounting-scheme huawei
huawei(config-aaa-accounting-huawei)#accounting-mode none
huawei(config-aaa-accounting-huawei)#quit
Create a local user with the user name shenzhen and the password shenzhen.
huawei(config-aaa)#local-user shenzhen@huawei service-type terminal password
shenzhen
Name the AAA domain huawei. Bind the domain with the accounting scheme named
huawei, authentication scheme named huawei.
huawei(config-aaa)#domain huawei
huawei(config-aaa-domain-huawei)#authentication-scheme huawei
huawei(config-aaa-domain-huawei)#accounting-scheme huawei
huawei(config-aaa-domain-huawei)#quit
huawei(config-aaa)#quit
Step 1: Choose Start > Control Panel > Network Connections. Right-click Local Area
Connection and then choose Properties.
Step 2: In the dialog box that is displayed,
1. On the General tab page, set Internet Protocol (TCP/IP) to Obtain an IP address
automatically.
2. On the Authentication tab page, select Enable IEEE 802.1x authentication for this
network.
3. Click OK.
Step 3: Right-click Local Area Connection and then choose Disable.
Step 4: Right-click Local Area Connection and then choose Enable.
After a while, the modem2 prompt icon will be displayed in the lower right corner on the
PC desktop. Click the icon. In the dialog box that is displayed, enter the user name
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Configuring the DSLAM Services
285