Example: Configuring The Isdn Pra Service (Based On The Sip Protocol) - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
3.3.10 Example: Configuring the ISDN PRA Service (Based on the
SIP Protocol)
This topic is applicable to the scenario where the ISDN users are connected to the MA5600T/
MA5603T/MA5608T through the ISDN primary rate interface (PRI).
Prerequisite
l
l
l
l
l
Service Requirements
l
l
Networking
Figure 3-18
Issue 01 (2014-04-30)
The MA5600T/MA5603T/MA5608T must use the SIP protocol to communicate with the
IMS.
The MG interface and the system parameters must be configured. For the related operations,
see Configuring an SIP Interface and (Optional) Configuring the System Parameters. The
MG interface must be in the normal state.
The PSTN user (Phone B in the example network) must be configured and can communicate
with other users in the normal state. For the configuration method, see
Configuring the VoIP PSTN Service
Users of the PBX must be configured and can communicate with each other in the normal
state.
The system must be configured with the EDTB board.
The PBX is connected to the MA5600T/MA5603T/MA5608T through the ISDN PRI. PRI
supports a data rate of 2048 kbit/s, including 30 B channels and one D channel. The rate
of both the B channel and the D channel is 64 kbit/s.
After the configuration is completed, users of the PBX can make calls successfully and can
communicate with users outside the PBX in the normal state.
shows an example of the ISDN PRA service.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Configuring the DSLAM Services
(SIP).
3.3.3 Example:
344