Huawei SmartAX MA5603T Configuration Manual page 771

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Step 2 Add an ONU.
Connect an ONU to GPON port 0/1/0. Set the ONU ID to 1, password to 0100000001, discovery
mode for password authentication to once-on, and management mode to OMCI. Bind the ONU
to ONU line profile fttd and ONU service profile fttd.
There are two methods of adding an ONU: add an ONU offline and confirm an automatically
discovered ONU.
l Add ONUs offline.
If the password of an ONU is known, run the ont add command to add an ONU offline.
huawei(config)#interface gpon 0/1
huawei(config-if-gpon-0/1)#ont add 0 1 password-auth 0100000001 once-on no-aging
omci ont-lineprofile-name
l Confirm automatically discovered ONUs
If the password or SN of an ONU is unknown, run the port portid ont-auto-find enable
command in GPON mode to enable the ONU auto-discovery function of the GPON port.
Then, run the ont confirm command to confirm the ONU.
huawei(config)#interface gpon 0/1
huawei(config-if-gpon-0/1)#port 0 ont-auto-find enable
huawei(config-if-gpon-0/1)#display ont autofind 0
the GPON port through optical splitters is displayed.
huawei(config-if-gpon-0/1)#ont confirm 0 ontid 1 password-auth 0100000001 once-
on no-aging omci ont-lineprofile-name
If multiple ONUs of the same type bound to the same line profile or service profile are connected to the
same port, you can bulk add ONUs by bulk confirming automatically discovered ONUs to make
configuration easier and more efficient. To do so, the preceding command can be modified as follows:
huawei(config-if-gpon-0/1)#ont confirm 0 all password-auth once-on no-agin omci
ont-lineprofile-name fttd
ont-srvprofile-name fttd
The password entered when you add an ONU to the OLT must be the same as that configured on the web
page. To configure the password of the ONU on the web page, see
Issue 01 (2014-04-30)
l In this example, the default alarm profile is used, and therefore the configuration of the
alarm profile is not required.
l Run the gpon alarm-profile add command to configure a GPON alarm profile, which
is used for monitoring the performance of an activated ONU line.
fttd ont-srvprofile-name fttd
//After this command is executed, the information about all ONUs connected to
fttd ont-srvprofile-name fttd
NOTE
NOTE
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
10 FTTD Configuration
Figure 10-3.
746