Configuration Procedure For Ge Remote Extended Subrack - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
l
l

11.4.2.3 Configuration Procedure for GE Remote Extended Subrack

Compared with a traditional network using VDSL2 modems to connect to users, the network
using a GE remote extended subrack requires the
subrack. The other service configuration process and methods are the same for the two networks
and therefore are not described in this section. For details, see the MA5600T Configuration
Guide or the MA5603T Configuration Guide. This section describes the service configuration
process for the FTTB/FTTC+HGW networking (FTTB is the abbreviation for fiber to the
building, FTTC for fiber to the curb, and HGW for home gateway).
Figure 11-13
Figure 11-13 Configuration roadmap for the FTTB/FTTC+HGW networking (voice service
provided through the HGW)
The following table describes the configuration steps.
Issue 01 (2014-04-30)
services are transmitted to PSTN networks through the splitter and therefore, FTTx network
data planning is not required for PSTN voice services.)
IPTV service data planning
Security data planning
shows the configuration roadmap for the FTTB/FTTC+HGW networking.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
11 FTTB and FTTC Solution Configuration
addition of a GE remote extended
1046