Configuring Onu Satop Connections - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Step 3 Configure the in-band management service port.
Set the management VLAN to 8, GEM port ID to 11, and user VLAN to 8. The OLT does not
rate limit the in-band management service port. Therefore, directly use the default traffic profile
6.
huawei(config)#service-port vlan 8 gpon 0/3/1 ont 1 gemport 11 multi-service
user-vlan 8 rx-cttr 6 tx-cttr 6
Step 4 Confirm that the connection between the management service ports on the OLT and ONU is
reachable.
l Run the ping ONU ip command on the OLT to verify the connectivity between the OLT and
ONU. If the OLT receives ICMP ECHO-REPLY packets from the ONU, the connection is
reachable.
l When the connection is reachable, you can remote log in to the ONU from the OLT and
configure the ONU.
Step 5 Configure the upstream port.
Add upstream port 0/19/0 (on the GICK board) to VLAN 100.
huawei(config)#port vlan 100 0/19 0
Step 6 Configure the GPON service port.
Set SVLAN ID to 300, GEM port ID to 12, and CVLAN ID to 300. Rate limit for upstream and
downstream packets is performed on the ONU instead of on the OLT. Therefore, use traffic
profile 6 (default). To limit the rate of the service port, run the traffic table ip command to add
a traffic profile and bind it to the service port.
The CVLAN must be the same as the upstream VLAN of the ONU.
huawei(config)#vlan 300 smart
huawei(config)#service-port vlan 300 gpon 0/3/1 ont 1 gemport 12 multi-service
user-vlan 300 rx-cttr 6 tx-cttr 6
----End

13.3.6.7 Configuring ONU SAToP Connections

This topic describes how to configure a SAToP connection of the IP+UDP encapsulation type
and a service VLAN to enable packets of base stations to be encapsulated on ONUs as Ethernet
packets and then forwarded based on VLANs and MAC addresses.
Data Plan
Configurati
on Item
EDTB (OLT)
Issue 01 (2014-04-30)
Data
Port: 0/5/0
Board IP address: 10.10.50.10
Board MAC address: dynamically obtained
Local UDP port number: 50048
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
13 FTTO Configuration (Large-sized Enterprise Access)
(remark
(remark 2)
1)
1353