Configuring Voip Pra Access - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
According to
are all translated to CLVAN 300. The OLT transparently transmits the packets. The traffic profile
10 is used.
huawei(config)#service-port vlan 300 gpon 0/3/1 ont 1 gemport 12 multi-service
user-vlan 300 rx-cttr 10 tx-cttr 10
----End

13.3.4.6 Configuring VoIP PRA Access

This topic describes how to configure VoIP PRA access. ONUs provide PRA E1 ports to access
the PRA PBX service and convert PRA signaling to ISDN Q.931-User Adaptation Layer (IUA)
signaling, achieving signaling exchange between ONUs and media gateway controller (MGCs).
Prerequisites
The H.248 protocol is a master/slave protocol which is used by an MGC to control access
gateways (AGs) to implement call connections. The data, including media gateway (MG)
interface attributes and voice user attributes on AGs, must be consistent with those on the MGC.
Therefore, before configuring the VoIP voice service, plan data with the MGC.
Context
IUA is the ISDN Q.931-User Adaptation Layer protocol. IUA links carry signaling exchanged
between ONUs and MGCs.
Data Plan
Table 13-8 Data plan for VoIP PRA service
Configuration
Item
VLAN
MG interface
IUA linkset
Issue 01 (2014-04-30)
13.2.2 Principle of VLAN Data
Data
VLAN ID: 300
IP address of the Layer 3 interface: 10.10.10.10/24
MG ID: 0
Media/signaling IP address: 10.10.10.10/24
MGC IP address: 200.200.200.200
Gateway IP address: 10.10.10.1
Protocol port: 2944
IUA link set ID: 1
Working mode of the link set: override
Interface ID (IID) generation mode: 2
Service environment of the IUA link set: client
Interlocking function: enabled
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
13 FTTO Configuration (Large-sized Enterprise Access)
Plan, VLANs of packets sent from the PRA PBX
1319