Principle Of Protocol Transparent Transmission Data Plan - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Parameter
T-CONT
DBA type
DBA bandwidth
Enterprise E1/T1 unified access (OLT Cascading)
The QoS policies for this scenario are the same as those for the
access

13.2.4 Principle of Protocol Transparent Transmission Data Plan

The enterprise access service involves transparent transmission of protocol packets. Different
equipment configurations are required for transparently transmitting different protocol packets.
Configurations for Protocol Transparent Transmission
Protocol Type Protocol Description
BPDU
ETH OAM
Broadcast
Layer 2/Layer 3
protocol
Issue 01 (2014-04-30)
Value
It is recommended that the number
of T-CONTs do not exceed 3. The
T-CONT ID ranges from 1 to 3.
Fixed bandwidth and minimum
delay
l E1 access: Nx8 Mbit/s is
recommended. (N is the
number of E1 lines.)
l T1 access: Nx6 Mbit/s is
recommended. (N is the
number of E1 lines.)
scenario.
STP, MSTP, RSTP, IS-
IS
IEEE 802.1ag
ARP
NTP, BGP, LDP, RSVP,
IGMP, PIM
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
13 FTTO Configuration (Large-sized Enterprise Access)
Remarks
It is recommended that all E1 lines
of the same ONU use the same T-
CONT.
The DBA must be configured
properly to achieve low delay, low
jitter, and zero packet loss so that
the quality of the T1 base station
access service can be ensured.
-
Enterprise E1/T1 unified
Configuration (remarks 1)
The function of transparently transmitting
BPDU packets must be enabled.
Configuration example:
huawei(config)#vlan service-profile
profile-id 1
huawei(config-vlan-srvprof-1)#bpdu
tunnel enable
No configuration is required because packets
are transparently transmitted by hardware.
No configuration is required because packets
are transparently transmitted by hardware.
No configuration is required because packets
are transparently transmitted by hardware.
1263