Optional) Configuring Vectoring - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
----End

11.4.2.7 (Optional) Configuring Vectoring

Vectoring configurations on VDSL2 lines cancel the far-end crosstalk (FEXT) of VDSL2 lines
to improve the line rate.
Context
For MA5623AR, when configuring vectoring, learn configuration item functions and
configuration methods beforehand by referring to
Issue 01 (2014-04-30)
1. Create an S-VLAN and add an upstream port to it.
Create S-VLAN 1000 with the common attribute and add upstream port 0/19/0 to the
S-VLAN.
huawei(config)#vlan 1000 smart
huawei(config)#port vlan 1000 0/19 0
2. Create a multicast service port.
Configure a service port with the user VLAN being 1000. The HGW is connected to
port 1/1/0 of the GE remote extended subrack. Upstream and downstream traffic is
rate-limited using a line profile. A traffic profile (traffic profile 10 in this example)
that does not limit rates is referenced.
huawei(config)#service-port vlan 1000 vdsl mode ptm 1/1/0 multi-service
user-vlan 1000 rx-cttr 10 tx-cttr 10
3. Set the IGMP version.
Set the IGMP version to IGMP v3.
huawei(config)#multicast-vlan 1000
huawei(config-mvlan1000)#igmp version v3
4. Set the IGMP mode.
Set the IGMP mode to IGMP proxy.
huawei(config-mvlan1000)#igmp mode proxy
Are you sure to change IGMP mode?(y/n)[n]:y
5. Configure the multicast upstream port.
Configure the IGMP upstream port as 0/19/0.
huawei(config-mvlan1000)#igmp uplink-port 0/19/0
6. Configure multicast programs.
Set the IP address of multicast programs to 224.1.1.10–224.1.1.100, and IP address
of the multicast server to 10.10.10.10.
huawei(config-mvlan1000)#igmp program add batch ip 224.1.1.10 to-ip
224.1.1.100
sourceip 10.10.10.10
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
11 FTTB and FTTC Solution Configuration
Table 11-33.
1053