Verifying Services - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
----End

11.3.1.10 Verifying Services

In the Fiber-to-the-building (FTTB) scenario, optical network units (ONUs) are installed in
buildings that are far from the central equipment room. ONUs support methods of remote service
verification such as Point-to-Point Protocol over Ethernet (PPPoE) dialup emulation and call
emulation. Remote site verification eliminates the need to go to site for a second time.
Prerequisites
ONUs are properly connected to upper-layer devices. The broadband remote access server
(BRAS) and media gateway controller (MGC)/IP Multimedia Subsystem (IMS) have been
configured.
Background Information
Remote
Service
Verificati
on
Method
PPPoE
emulation
dialup
Issue 01 (2014-04-30)
b. Run the pitp enable command to enable PITP at the VLAN level.
c. Run the commit command to make the profile configuration take effect.
d. Run the quit command to quit the VLAN service profile mode.
e. Run the vlan bind service-profile command to bind the created VLAN
service profile to a VLAN.
– The service port level: In global config mode, run the pitp service-port
command to enable PITP at the service port level.
2. On the OLT, run the pitp permit-forwarding service-port command with the
enable parameter selected, to allow ONU PPPoE packets to carry a vendor tag.
Function
By emulating PPPoE terminal
software, an ONU dials up and
interacts with the BRAS, to verify the
connectivity between the ONT and
BRAS.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
11 FTTB and FTTC Solution Configuration
Remarks
PPPoE dialup emulation requires a
service flow that does not belong to a
QinQ VLAN.
The user name, password, and
authentication mode must be
configured on the BRAS before the
PPPoE dialup emulation starts.
An ONU supports a maximum of one
PPPoE dialup emulation.
879