Configuring Ethernet Access Service Ports On Onus - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
service
user-vlan 300 rx-cttr 10 tx-cttr 10
Step 4 Configure attributes for protocol transparent transmission.
Create a VLAN service profile, enable the VLAN Layer 2 interoperation function, and configure
attributes for protocol transparent transmission. Then, bind the profile to VLAN 300. For details
on data planning for protocol transparent transmission, see
Transparent Transmission Data
huawei(config)#vlan service-profile profile-id 1
huawei(config-vlan-srvprof-1)#user-bridging enable
huawei(config-vlan-srvprof-1)#bpdu tunnel enable
huawei(config-vlan-srvprof-1)#ospf tunnel enable
huawei(config-vlan-srvprof-1)#rip tunnel enable
huawei(config-vlan-srvprof-1)#vtp-cdp tunnel enable
huawei(config-vlan-srvprof-1)#commit
huawei(config-vlan-srvprof-1)#quit
huawei(config)#multicast-unknown policy service-port 301 transparent
huawei(config)#multicast-unknown policy service-port 302 transparent
huawei(config)#vlan bind service-profile 300 profile-id 1
----End

13.3.1.6 Configuring Ethernet Access Service Ports on ONUs

This topic describes how to configure service ports on ONUs and configure upstream VLANs
to make the ONU-to-user connection reachable and create ONU-to-OLT upstream data channels.
Data Planning
Configuration
Item
Port
SVLAN
Traffic profile
NOTE
Data plans for ONU1 and ONU 2 are the same. This topic uses one ONU as an example to describe how to
configure the ONU.
Procedure
Step 1 Remotely log in to an ONU to configure the ONU.
Issue 01 (2014-04-30)
Plan.
Data
Upstream port: 0/0/1
Service port: 0/3/1
VLAN ID: 300
VLAN type: smart
VLAN attribute: common
Profile ID: 8
Assured rate: no rate limit
Priority source: user-cos
Default riority: 4
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
13 FTTO Configuration (Large-sized Enterprise Access)
13.2.4 Principle of Protocol
//Mandatory
1278