Configuring The Service Channel Between The Olt And The Onu - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
huawei(config-if-vlanif8)#ip address 192.168.50.1 24
huawei(config-if-vlanif8)#quit
Step 2 Configure the inband management VLAN and IP address of the ONU.
Configure the static IP address of the ONU to 192.168.50.2/24, gateway to 192.168.50.254, and
the management VLAN ID to 8 (the same as the management VLAN of the OLT).
huawei(config)#interface gpon 0/2
huawei(config-if-gpon-0/2)#ont ipconfig 1 1 static ip-address 192.168.50.2 mask
255.255.255.0 gateway
192.168.50.254 vlan 8
huawei(config-if-gpon-0/2)#quit
Step 3 Configure an inband management service port.
Configure the management service port ID to 1, management VLAN ID to 8, GEM port ID to
11, and user-side VLAN ID to 8. The OLT does not limit inband management service flows.
Therefore, it is recommended that you use default traffic profile 6.
huawei(config)#service-port 1 vlan 8 gpon 0/2/1 ont 1 gemport 11 multi-service
user-vlan 8 rx-cttr 6 tx-cttr 6
Step 4 Confirm that the management channel between the OLT and the ONU is available.
l On the OLT, run the ping 192.168.50.2 command to check the connectivity between the
OLT and the ONU. The ICMP ECHO-REPLY packet from the ONU should be received.
l On the OLT, you can remote log in to the ONU to perform the configuration.
----End

11.3.2.5 Configuring the Service Channel Between the OLT and the ONU

Various service flows can be configured on the OLT for different services so that service packets
on the ONU can be forwarded at Layer 2 according to the planned VLAN and forwarding
policies.
Context
Service flows can be added in two modes, as described in
required.
Table 11-10 Adding service flows
Mode
Add service flows
one by one.
Add service flows
in batches.
Issue 01 (2014-04-30)
Command
service-port
multi-service-port
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
11 FTTB and FTTC Solution Configuration
Table 11-10. Select either mode as
Remarks
-
You need to specify the ontid +
gemindex to identify a service flow
and ensure that the number of GEM
ports is the same as the number of
VLANs on the user side.
889