Huawei SmartAX MA5603T Configuration Manual page 451

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
5.
6.
Networking
Figure 4-7
Figure 4-7 Example network of TDM PWE3 (MPLS-based)
SHDSL Modem
Data Plan
Table 4-8
Table 4-8 Data plan for configuring TDM PWE3 (MPLS-based)
Parameter
H802EDTB board
SPUB board
MPLS
Issue 01 (2014-04-30)
The packets are sent over the PSN network to the peer PWE3 gateway (such as the PTN).
The PWE3 gateway restores the E1 signals from the packets and then sends them to the
DDN network or SDH network.
shows an example network of TDM PWE3 (MPLS-based).
Access
Node
SHDSL
PRI PBX
E1
lists the data plan for configuring TDM PWE3 (MPLS-based).
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Configuration Example of the Private Line Service
MPLS
Network
TDM PWE3
Data
Board slot: 0/4
E1 port: 0/4/5
Board slot: 0/5
VLAN for MPLS forwarding: 4001
IP address of VLAN interface 4001: 10.50.50.50/24
MPLS LSR ID: 3.3.3.3
Global MPLS LDP: enabled
MPLS LDP for VLANIF 4001: enabled
MPLS Layer 2 VPN: enabled
PWE3
Gateway
E1
SDH
E1
426