Huawei SmartAX MA5603T Configuration Manual page 35

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
S6-5
1
1
1
1
1
Procedure
Step 1 Remove the cable connector if the H801ESC board is connected to an environment monitoring
cable.
Step 2 Loosen the screws on the H801ESC board anticlockwise by using the Phillips screwdriver, as
shown in (1) of
Figure 1-3 Removing the H801ESC board
Step 3 Hold the ejector lever of the front panel and remove the H801ESC board from the PDU, as shown
in (2) of
Issue 01 (2014-04-30)
S6-4 S6-3
1 0
1 1
1 1
1 1
1 1
Figure 1-3.
Figure 1-3.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
S6-2 S6-1
1 1
0 0
0 1
1 0
1 1
1 Commissioning
Address
Value of Sub-
nodes
11011(27)
11100(28)
11101(29)
11110(30) is
used by the
ESC board, and
the H801ESC
board cannot be
set to this value.
11111(31)
10