Configuring The Attributes Of An Upstream Ethernet Port - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
MA5603T/MA5608T is deployed in floor 1, building 01 of community A. To add port
description according to the plan, do as follows:
huawei(config)#port desc 0/2/0 description A-01-01/0-2-0
huawei(config)#display port desc 0/2/0
------------------------------------------------------------
F/ S/ P
------------------------------------------------------------
0/ 2/ 0
------------------------------------------------------------

2.3 Configuring the Attributes of an Upstream Ethernet Port

This topic describes how to configure the attributes of a specified Ethernet port so that the system
communicates with the upstream device in the normal state.
Prerequisites
The board in the GIU slot must be in position and must work in the normal state.
Context
The MA5600T/MA5603T/MA5608T should be interconnected with the upstream device
through the Ethernet port. Therefore, pay attention to the consistency of port attributes.
Default Configuration
Table 2-1
Table 2-1 Default settings of the attributes of an Ethernet port
Parame
ter
Default
Setting
(Optical
Port)
Issue 01 (2014-04-30)
IMA Group Port Description
- A-01-01/0-2-0
lists the default settings of the attributes of an Ethernet port.
Auto- Port rate
negotiation
mode of the
port
l GICD/ l FE optical
GICF/ port: 100
GICK: Mbit/s
enabled
l GE
l Other GIU optical
board: port: 1000
disabled Mbit/s
l 10GE
optical
port:
10000
Mbit/s
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Duplex Network
mode cable
adaptation
mode
Full-duplex, Not
read only supported
2 Basic Configurations
Flow
control
Disabled
223