Huawei SmartAX MA5603T Configuration Manual page 385

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Table 3-16 Data plan of VAG1
Item
SIP interface
data
(The data
configuration
must be the
same as the data
configuration
on the IMS.)
Voice user data
(The data
configuration
Issue 01 (2014-04-30)
Media and Media and
signaling signaling
parameter upstream VLAN
s
Media and
signaling
upstream port
Media IP address
and signaling IP
addresses
Default gateway
IP address
Attributes SIP interface ID
of the SIP
Signaling port ID
interface
of the SIP
NOTE
interface
Parameter
s listed
IP address of the
here are
primary IMS core
mandator
network device to
y, which
means which the SIP
that the
interface belongs
SIP
interface
Port ID of the
fails to be
primary IMS core
enabled if
network device to
these
which the SIP
parameter
interface belongs
s are not
configure
Transmission
d.
mode of the SIP
interface
Homing domain
name of the SIP
interface
Index of the
profile used by the
SIP interface
Slot of the voice service board
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Configuring the DSLAM Services
Remarks
Standard VLAN 30 is adopted.
In this office, all the services are
transmitted upstream through the
control board. Therefore, port 0/19/0 is
used as the upstream port of the voice
service.
These two IP addresses are both
10.20.10.10.
The IP address of the next hop from the
MA5600T/MA5603T/MA5608T to the
IMS core network device is 10.20.10.1.
0 and 1
5060
10.20.20.100
5060
UDP
huawei
Default profile (profile 1)
The ASPB service board in slot 0/2 and
0/3.
360