Configuring H.248 Voice Service (On The Onu) - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
NOTE
huawei(config)#service-port 101 vlan 1001 eth 0/3/1 multi-service user-vlan
untagged rx-cttr 8 tx-cttr 8
Step 6 Save the data.
huawei(config)#save
----End

11.3.1.7 Configuring H.248 Voice Service (on the ONU)

This topic describes how to configure the voice service on the ONU based on the H.248 protocol
to provide the high quality and low cost VoIP service for users.
Prerequisites
l
l
Precautions
1.
2.
This operation interrupts the ongoing services carried on the currently used MG interface. Hence,
exercise caution when performing this operation.
Data plan
For details about the data plan, see
Item
MG
interface
data
Issue 01 (2014-04-30)
This example creates one service port as an example. Each service port maps a user. When configuring
another service port, map the corresponding SVLAN.
The media gateway controller (MGC) interface data and the PSTN user data corresponding
to the media gateway (MG) interface is configured on the MGC.
Ensure that the Status of the voice board on the ONU is Normal by running the display
board 0 command.
An ONU supports both the H.248 and SIP protocols; however, these two protocols are
mutually exclusive. You can run the display protocol support command to query the
currently supported voice protocol.
If the voice protocol needs to be switched, you need to delete the MG interface first and
run the protocol support command to switch the protocol. After the configuration is
complete, save the configuration and restart the system to make the configured protocol
take effect.
CAUTION
Media Media and signaling
and upstream VLANs
signalin
Media and signaling
g
upstream port
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
11 FTTB and FTTC Solution Configuration
11.2.5 Principle of VoIP Service Data
Data
200
0/0/1
Plan.
869