Configuring The Btv Service - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Step 7 (Optional) Configure the SIP user codec.
Run the sippstnuser codec command to configure the SIP user codec. The SIP user codec will
not be configured independently in this example.
Step 8 Save the data.
huawei(config)#save
----End

12.4.2.9 Configuring the BTV Service

The OLT is connected to the remote gateway ONU through a GPON port to provide users with
the bridge WAN multicast service.
Prerequisites
l
l
l
Data Plan
Table 12-45 Data plan
Item
ONU line profile
ONU service profile
Traffic profile
Multicast service data
Issue 01 (2014-04-30)
SIP interfaces. If you use these two commands to bind the SIP service data profiles to SIP
ports repeatedly, the last configurations take effect.
In this example, the default digitmap profile, namely digitmap profile 1 is used.
The IPTV WAN ports on the ONU use factory defaults.
The OLT has been connected to the BRAS and the multicast source.
The ONU has been added to the OLT. For details, see
OLT.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
12 FTTO Configuration(SOHO and SME)
Data
Profile name: ftto_line
T-CONT ID: 4
GEM port ID: 13
Profile name: ftto_ser
ONU port capability set: adaptive
ID: 8
802.1p priority: 4
CIR: off (unlimited)
Priority-based scheduling policy: local-setting
Multicast protocol: IGMP proxy
Multicast version: IGMPv2
Multicast program: dynamic obtaining mode
12.3.3 Adding an ONU to an
1222