Configuring Satop Connections And Service Ports - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
255.255.255.0 gateway
192.168.50.1 vlan 8
huawei(config-if-gpon-0/3)#quit
Step 3 Configure the in-band management service port.
Set the management VLAN to 8, GEM port ID to 11, and user VLAN to 8. The OLT does not
rate limit the in-band management service port. Therefore, directly use the default traffic profile
6.
huawei(config)#service-port vlan 8 gpon 0/3/1 ont 1 gemport 11 multi-service
user-vlan 8 rx-cttr 6 tx-cttr 6
Step 4 Confirm that the connection between the management service ports on the OLT and ONU is
reachable.
l Run the ping ONU ip command on the OLT to verify the connectivity between the OLT and
ONU. If the OLT receives ICMP ECHO-REPLY packets from the ONU, the connection is
reachable.
l When the connection is reachable, you can remote log in to the ONU from the OLT and
configure the ONU.
----End

14.4.2.5 Configuring SAToP Connections and Service Ports

This topic describes how to configure a SAToP connection of the IP+UDP encapsulation type
and a service port to enable packets of base stations to be encapsulated on ONUs and restored
on OLTs.
Prerequisites
Required hardware is available:
l
l
l
l
Context
Figure 14-12
following figure, after TDM signals are encapsulated in the IP+UDP format, an outer VLAN
tag and an Ethernet header are added to the TDM signals. Then the TDM signals become a
standard Ethernet packet that is transmitted on the PON line between the ONU and OLT.
Issue 01 (2014-04-30)
Main control boards on the OLT: SCUN+CKMC/CKMD
Upstream board on the OLT: EDTB (for E1 upstream transmission)
Service board on the OLT: GPBD
ONU: MA5612 (configured with the E81A board) or MA5628
shows SAToP encapsulation for E1 base station access service. As shown in the
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
14 FTTM Configuration (Base Station Access)
1420