Configuring Layer 2 Interoperation Service Ports On Olt - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide

12.4.3.4 Configuring Layer 2 Interoperation Service Ports on OLT

This topic describes how to configure service ports on the OLT for Layer 2 interoperation so
that data packets sent from different ONUs can be forwarded based on the same VLAN at Layer
2.
Prerequisites
1.
2.
Data Plan
Configuratio
n Item
Layer 2
interoperation
SVLAN
Traffic profile
NOTE
For detailed data planning, see
Procedure
Step 1 Configure an SVLAN and add an upstream port to it.
Set the SVLAN ID of the Layer 2 interoperation service to 300, VLAN type to smart VLAN,
and add upstream port 0/19/0 to the VLAN.
huawei(config)#vlan 300 smart
huawei(config)#port vlan 300 0/19 0
Step 2 Configure a traffic profile.
Add a new traffic profile 10 and set the assured rate to 100 Mbit/s. Packets transmitted upstream
use the priority (4 by default) copied from the user side. Packets transmitted downstream use
the priority carried by themselves.
huawei(config)#traffic table ip index 10 cir 102400 priority user-cos 4 priority-
policy tag-in-package
Step 3 Configure a service port to receive and transparently transmit the Layer 2 interoperation service
that is sent from ONU 1 and ONU 2.
Issue 01 (2014-04-30)
The main control board on the device is an SCUN board.
The ARP proxy function is disabled using the arp proxy disable command. (The Layer 2
interoperation function and ARP proxy function are mutually exclusive.)
Data
OLT VLAN ID (the OLT transparently transmits VLANs of ONU): 300
VLAN forwarding mode: vlan-mac (default)
ONU VLAN ID: 300
Service flow ID: 301
Profile ID: 10
Assured bandwidth: 100 Mbit/s
Priority source: user-cos
Default priority: 4
13.2.2 Principle of VLAN Data
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
12 FTTO Configuration(SOHO and SME)
Plan.
1241