Verifying Services - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
----End

11.3.3.16 Verifying Services

This topic describes how to verify service configurations in the FTTB+HGW networking (ONU
providing the VoIP service). In this scenario, the ONUs are placed in the building far away from
the central office. The ONUs provide remote service verification methods including PPPoE
dialup emulation, call emulation, and multicast emulation for configuration and commissioning
engineers to verify services remotely after services are configured.
Prerequisites
ONUs and upper-layer devices have been connected properly. The BRAS and MGC/IMS have
been configured.
Background Information
The following table lists the remote verification methods for different services.
NOTE
Currently, the VoD service does not support remote verification.
Issue 01 (2014-04-30)
Parameter
VLAN
enabling
VLANID
[1-4094]
VPI/VCI
Binding item
Mode
Encapsulation
mode
c. Click OK to save the settings.
3. Restart the HGW.
Choose Management > Device Management and click Restarting the Device.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
11 FTTB and FTTC Solution Configuration
Value
Enable: VLAN tags are added to upstream packets.
NOTE
When multicast service flows are created on the ONU, the value is
Disable if uservlan is untagged and the value is Enable if
uservlan is tagged.
Multicast VLAN ID on the HGW when multicast service
flows are created on the ONU. In this example, set this
parameter to 43.
Set the VPI/VCI to the same as that configured on the devices
at the central office. In this example, set this parameter to
0/35.
LAN4
Bridge
LLC
969