Huawei SmartAX MA5603T Configuration Manual page 697

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Issue 01 (2014-04-30)
NOTE
The default voice protocol is SIP. Therefore, change the voice protocol first.
a. Choose Voice > SIP/H.248 Protocol Conversion.
b. In the pane on the right, set Voice to H.248.
c. Click Apply.
2. Configure parameters for the voice WAN interface.
a. Choose WAN > WAN Configuration.
b. In the right pane, click New. In the dialog box that is displayed, set the parameters
as follows:
– Select Enable WAN Connection to enable the new WAN connection.
– Set Encapsulation mode to IPoE.
– Set Service Type to VOIP. (For configuring the VoIP service, VoIP or a
combination containing VoIP needs to be selected.)
– Set WAN mode to Route WAN.
– Select Enable VLAN.
– Set VLAN ID to 300. (The VLAN ID of the ONT must be the same as the
user-side VLAN ID configured on the OLT.)
– Set 802.1p to 5.
– Set IP Acquisition Mode to DHCP.
c. Click Apply.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 FTTH Configuration
672