Huawei SmartAX MA5603T Configuration Manual page 373

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
l
l
Procedure
Step 1 (Optional) Configure the working mode of the board
Configure the working mode of the board to voice.
NOTE
The working sub-mode of the board can be configured only when the working mode of the board is configured
to voice. By default, the working mode of the board is voice.
huawei(config)#interface edt 0/3
huawei(config-edt-0/3)#board workmode voice
Step 2 (Optional) Configure the working sub-mode of the board.
According to the service requirement, configure the working sub-mode of the board to service
mode. By default, the working sub-mode of the board is service.
huawei(config-edt-0/3)#runmode service
Step 3 (Optional) Configure the clock source of the board.
Configure the E1 line clock on port 0/3/0 as the clock source.
NOTE
You can select the line clock or system clock as the clock source of the board according to your requirements.
By default, the system clock is used as the clock source.
huawei(config-edt-0/3)#set clockmode line 0
Step 4 Configure the attributes of the SHDSL port.
Configure the signaling mode of SHDSL port 0/3/16 to CCS. PRA D channel signaling is
transmitted in timeslot 16 and timeslot 0 is used for frame synchronization.
huawei(config-edt-0/3)#shdslport signal 16 CCS
huawei(config-edt-0/3)#quit
Step 5 Add an IUA link set and IUA links.
In the SIGTRAN mode, configure the SIGTRAN protocol stack. Add an IUA link set, and then
add IUA links.
huawei(config)#sigtran
huawei(config-sigtran)#iua-linkset add 1 mgid 0 jointly-work enable trafficmode
override
iid-map 2 pendingtime cs-mode client
huawei(config-sigtran)#iua-link add 15 1 1401 10.13.4.116 1400 10.14.1.2
jointly-work-with primary-mgc priority 3
NOTE
Step 6 Configure a PRA user.
huawei(config)#esl user
huawei(config-esl-user)#mgprauser add 0/3/16 0 0 terminalid 0
huawei(config-esl-user)#quit
Step 7 Save the data.
huawei(config)#save
----End
Issue 01 (2014-04-30)
An MG interface must be created and must communicate with the MGC in the normal state.
An SHDSL modem must be correctly connected and the SHDSL port(s) must be activated.
All the ISDN call control messages are sent from the IUA link to the softswitch, whereas the system uses
the bearer control messages to communicate with the softswitch through H.248.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Configuring the DSLAM Services
348