Huawei SmartAX MA5603T Configuration Manual page 614

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
l
Issue 01 (2014-04-30)
Run the display traffic table ip command to query the existing traffic profiles in the
system. If the existing traffic profiles in the system do not meet the requirements, run
the traffic table ip command to add a traffic profile.
Set the profile name to ftth_voip and do not limit the upstream and downstream rates.
Set the priority to 5 and packets are scheduled according to the priority carried.
huawei(config)#traffic table ip name ftth_voip cir off priority 5 priority-
policy
local-setting
2. Configure the mapping relationship between a GEM port and a VLAN.
The service flow of user VLAN 300 is mapped to GEM port 12 in the ONT line profile.
huawei(config)#ont-lineprofile gpon profile-name ftth
huawei(config-gpon-lineprofile-1)#gem mapping 12 2 vlan 300
huawei(config-gpon-lineprofile-1)#commit
huawei(config-gpon-lineprofile-1)#quit
3. Create a service VLAN and add an upstream port to it.
Add upstream port 0/19/0 to VLAN 300.
huawei(config)#vlan 300 smart
huawei(config)#port vlan 300 0/19 0
4. Create service flows.
Set the service VLAN to 300, GEM port ID to 12, and user VLAN to 300, and use
traffic profile ftth_voip.
huawei(config)#service-port vlan 300 gpon 0/1/0 ont 1 gemport 12 multi-
service
user-vlan 300 inbound traffic-table name ftth_voip outbound traffic-table
name
ftth_voip
huawei(config)#service-port vlan 300 gpon 0/1/0 ont 2 gemport 12 multi-
service
user-vlan 300 inbound traffic-table name ftth_voip outbound traffic-table
name
ftth_voip
5. Enable the ARP proxy function.
Voice media streams for different users of the same SVLAN fail to interchange
because the service ports of the smart VLAN are isolated from each other. Therefore,
the ARP proxy function needs to be enabled on the OLT.
huawei(config)#arp proxy enable
huawei(config)#interface vlanif 300
huawei(config-if-vlanif300)#arp proxy enable
huawei(config-if-vlanif300)#quit
6. Save the data.
huawei(config)#save
Configure the ONT on the Web page.
Log in to the Web page and then configure the ONT on the Web page.
1. Configure the IP address of the PC network adapter to be in the same network segment
with the IP address of the local maintenance Ethernet port on the ONT (default:
192.168.100.1).
2. Open the Web browser, and enter the IP address (https://192.168.100.1:80 or http://
192.168.100.1) (https with high priority is recommended) of the local maintenance
Ethernet port on the ONT. In the login window that is displayed, enter the user name
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 FTTH Configuration
589