Configuring Ma5600T-1 - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Item
Multicast
server
EMU
DHCP
server
Upper-
layer
device
NOTE

7.3 Configuring MA5600T-1

This topic describes how to configure MA5600T-1.
Procedure
Step 1 Confirm the board.
huawei>enable
huawei#config
huawei(config)#board confirm 0
Step 2 Configure the NMS.
1.
Issue 01 (2014-04-30)
MA5600T-1
10.10.10.10
Fan monitoring
DHCP server1: 10.1.1.2 (active), 10.1.1.3 (standby)
Gateway: 10.1.1.1/24
DHCP server2: 10.4.4.2 (active), 10.4.4.3 (standby)
Gateway: 10.4.4.1/24
The upper-layer device supports the DHCP option82 function.
The BRAS supports the PITP, Stacking, and QinQ function.
The BRAS supports inner and outer VLAN tags.
The VLAN ID of the traffic flow sent from the IP network to the DSLAM is 100.
The upper-layer device classifies the downstream traffic. Different services carry
different 802.1p labels.
The VLAN mapping to the DSLAM is configured at the upper-layer device.
l In this networking, MA5600T-1 can be replaced with a GE switch or a BRAS.
l The upstream port of the MA5600T supports the port aggregation function. In the actual network
planning, you can aggregate multiple upstream ports for use.
l In this networking, the four MA5600Ts support the ADSL2+, SHDSL, VDSL2, GPON, and POTS
services. You can plan the services according to your actual network conditions.
Configure the IP address of the inband NMS interface.
l Create the NMS VLAN.
huawei(config)#vlan 10 standard
l Add the upstream port.
huawei(config)#port vlan 10 0/19 0-1
It will take several minutes, and console may be timeout, please use
command
idle-timeout to set time
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
MA5600T-2 MA5600T-3
7 Example: Subtending Networking
MA5600T-4
511