Configuring Docsis Event Reporting - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
huawei(config-aaa-authen-login-auth)#authentication-mode hwtacacs
huawei(config-aaa-authen-login-auth)#quit
huawei(config-aaa)#quit
huawei(config)#hwtacacs-server template ma56t-login
huawei(config-hwtacacs-ma56t-login)#hwtacacs-server authentication 10.10.66.66
1812
huawei(config-hwtacacs-ma56t-login)#hwtacacs-server authentication 10.10.66.67
1812 secondary
huawei(config-hwtacacs-ma56t-login)#quit
huawei(config)#aaa
huawei(config-aaa)#domain isp1
huawei(config-aaa-domain-isp1)#authentication-scheme login-auth
huawei(config-aaa-domain-isp1)#hwtacacs-server ma56t-login
huawei(config-aaa-domain-isp1)#quit
huawei(config-aaa)#quit

2.5 Configuring DOCSIS Event Reporting

DOCSIS 3.0 defines various DOCSIS events, such as authentication failure and CM certificate
error events. Configuring DOCSIS event reporting helps you obtain MA5600T/MA5603T/
MA5608T and CM running status.
Procedure
Step 1 Run the cable event loghost ipServerIpAddress command to set the IP address of a log host to
which DOCSIS events are reported.
Step 2 Run the cable event level report { localVolatile | trap | syslog } command to configure the
mode and priority of reporting DOCSIS events.
The modes of reporting DOCSIS events include localVolatile, trap, and syslog.
l localVolatile: indicates that the DOCSIS events are saved to MA5600T/MA5603T/
MA5608T local logs but not to the buffer. The MA5600T/MA5603T/MA5608T does not
save the DOCSIS events and clears them after being reset. Configure the localVolatile mode
before setting the mode of reporting DOCSIS events to trap or syslog.
l trap: reports DOCSIS events to a log host, which is generally the U2000, as traps. After
setting this mode, run the snmp-agent target-host trap-hostname command to configure
the log host.
l syslog: reports DOCSIS events to a log host as system logs, which are displayed after the
log host software parses them.
The mode of reporting DOCSIS events varies depending on the priorities of the DOCSIS events.
l Default mode of reporting DOCSIS events with emergency or alert priorities: localVolatile
l Default mode of reporting DOCSIS events with critical, error, warning, or notice priorities:
trap, syslog, and localVolatile
l Default mode of reporting DOCSIS events with information or debugging priorities: not
reported
----End
Example
The following is an example of the configurations used to enable the CM management feature:
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Basic Configurations
250