Example: Configuring The Xdsl Pppoa Internet Access Service - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
3.1.3 Example: Configuring the xDSL PPPoA Internet Access
Service
This topic describes how to configure a user so that the user can access the MA5600T/MA5603T/
MA5608T in the xDSL mode, and then access the Internet in the PPPoA mode at a rate of 2048
kbit/s.
Service Requirements
l
l
l
l
l
Figure 3-3
Figure 3-3 Example network of the xDSL PPPoA Internet access service
Prerequisite
l
Procedure
Step 1 Create a VLAN.
Create smart VLAN 50.
huawei(config)#vlan 50 smart
Issue 01 (2014-04-30)
The user accesses the Internet in the PPPoA mode.
User packets, which carry a single VLAN tag, are transmitted in the upstream direction,
and the services of multiple users are converged into one VLAN. This is called the N:1
access.
PITP is enabled to protect user accounts from theft and roaming.
A traffic profile is adopted for rate limitation. The user access rate is 2048 kbit/s.
Dual GE ports are adopted for upstream transmission to ensure reliability. Link aggregation
is configured for the two upstream ports.
shows an example network of the xDSL PPPoA Internet access service.
The AAA function must be configured.
– To enable the AAA function on the device, see
– If the AAA function is implemented by the BRAS, a connection to the BRAS must be
established. The BRAS should be capable of identifying the VLAN tag of the
MA5600T/MA5603T/MA5608T in the upstream direction. For the identification
purpose, the user name and password for dial-up Internet access must be configured on
the BRAS.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Configuring the DSLAM Services
2.4 Configuring AAA.
267