Networking Scenarios And Hardware Configurations (P2P) - Huawei SmartAX MA5603T Configuration Manual

Access module
Hide thumbs Also See for SmartAX MA5603T:
Table of Contents

Advertisement

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Network
ing
Scenario
9.7.2
Bridging
ONT +
HGW
Network
Scenario
9.7.3
Gateway
ONT
Network
Scenario
NOTE
The preceding three networking modes for GPON access services are in non-simplified mode. In simplified
mode, the triple play service is used as an example to describe how to configure a GPON access service. For
details, see
9.4 Networking Scenarios and Hardware Configurations
(P2P)
This section describes fiber to the home (FTTH) networking scenarios and hardware
configurations of an optical line terminal (OLT) and optical network terminals (ONTs).
Issue 01 (2014-04-30)
Description
The HGW integrating an
IAD provides Internet, voice
over Internet Protocol
(VoIP), and Internet
Protocol television (IPTV)
services to users.
Services are implemented on
the HGW, and the bridging
ONT works with the OLT to
provide Layer 2 channels.
The ONT integrating an IAD
provides Internet, VoIP, and
IPTV services to users.
The HGW ONT facilitates
interconnection of home
devices by providing Layer 3
services, such as Point-to-
Point Protocol over Ethernet
(PPPoE)/DHCP dial-up,
network address translation
(NAT), and Internet Group
Management Protocol
(IGMP) snooping. This
scenario provides fine-
grained management
channels and service control,
and applies to Layer 3
networking.
9.7.4 Configuring Triple Play Service (Simplified
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
OLT Device
(Main Control Board
+Service Board
+Upstream Board)
Mode).
9 FTTH Configuration
ONT Device
551

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Smartax ma5600tSmartax ma5608t

Table of Contents