Huawei SmartAX MA5603T Configuration Manual page 625

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Step 5 Configure the mode of issuing VoIP services.
Run the ont voip config-method command to configure the mode of issuing VoIP services. If
the mode of issuing VoIP services is not default or omci, run this command to set the mode to
default or omci. You can run the display ont info command to query the mode of issuing VoIP
services.
In this example, the mode is default.
Step 6 Configure ONT voice service profiles.
ONT voice service profiles include the interface common profile, MGC interface profile, and
POTS port profile.
l Interface common profile: saves common attributes of an ONT voice interface, including the
fax mode, fax/modem negotiation mode, and priority of the coding and decoding mode.
l MGC interface profile: saves the IP address or domain name of the MGC, protocol port ID
of the MGC transport layer to which the MG interface belongs, and DSCP priority of media
packets.
l POTS port profile: saves physical attributes of a POTS port on an ONT, including the
impedance, transmitting gain, receiving gain, and signaling type of the POTS port.
1.
2.
3.
Step 7 Configure the IP addresses of ONT SIP users.
For ONT 1 and ONT 2, configure the IP address obtaining mode to DHCP mode, set the
management VLAN to VLAN 20, and use default values for other parameters.
huawei(config)#interface gpon 0/1
huawei(config-if-gpon-0/1)#ont ipconfig 0 1 dhcp vlan 20
huawei(config-if-gpon-0/1)#ont ipconfig 0 2 dhcp vlan 20
Step 8 Configure H.248 POTS users.
1.
Issue 01 (2014-04-30)
Configure an interface common profile.
Run the display ont-mg-attribute-profile command to query the existing interface
common profile in the system. If the existing interface common profile in the system does
not meet the requirements, run the ont-mg-attribute-profile add command to add an
interface common profile.
In this example, the default interface common profile, namely interface common profile 1
is used.
Configure an MGC interface profile.
Run the display ont-mgc-profile command to query the existing MGC interface profile in
the system. If the existing MGC interface profile in the system does not meet the
requirements, run the ont-mgc-profile add command to add an MGC interface profile.
Create MGC interface profile 2, set the IP address of the MGC to 200.200.200.200, and
use default values for other parameters.
huawei(config)#ont-mgc-profile add profile-id 2 primary-mgc 200.200.200.200
Configure a POTS port profile.
Run the display ont-pots-profile command to query the existing POTS port profile in the
system. If the existing POTS port profile in the system does not meet the requirements, run
the ont-pots-profile add command to add a POTS port profile.
In this example, the default POTS port profile, namely POTS port profile 1 is used.
Add an H.248 interface and apply an MGC interface profile to the interface.
For ONT 1 and ONT 2, set the MG ID to 1, apply MGC interface profile 2 to ONT 1 and
ONT 2, and use default values for other parameters.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 FTTH Configuration
600