Huawei SmartAX MA5603T Configuration Manual page 808

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Data plan
Item
PPPoE
dialup
emulation
parameters
Call
emulation
parameters
Multicast
emulation
parameters
Procedure
l
Issue 01 (2014-04-30)
Data
PPPoE user name: test@huawei
Password: test
ONU POTS ID: 1
Multicast service flow ID: 1
MVLAN: 1000
IP address of the multicast
program: 224.1.1.10
Verify the Internet access service using PPPoE dialup emulation.
1. In the xPON board mode, run the pppoe simulate start command to start a PPPoE
dialup emulation test. The following test uses GPON as an example:
huawei(config)#interface gpon 0/1
huawei(config-if-gpon-0/1)#pppoe simulate start
{ portid<U><0,7> }:0
{ ontid<U><0,127> }:1
{ eth<K>|untagged<K>|vdsl|vlanid<U><0,4095> }:vdsl
{ ont-portid<U><1,8> }:1
{ untagged<K>|vlanid<U><0,4095> }:100
{ priority<U><0,7>|user-name<K> }:user-name
{ username<S><Length 1-64> }:test@huawei
{ user-password<K> }:user-password
{ password<S><Length 1-64> }:test
{ authentication-mode<K> }:authentication-mode
{ protocol<E><chap,pap> }:chap
Command:
pppoe simulate start 0 1 vdsl 1 100 user-name test@huawei user-
password
test authentication-mode chap
huawei(config-if-gpon-0/1)#
----------------------------------
ONT PPPoE Test Result
----------------------------------
F/S/P
ONT-ID
ONT VDSL Port ID
ONT Vlan ID
Vlan Priority
Emluator result
----------------------------------
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Remarks
The user name, password, and
authentication mode for the emulation test
must be configured on the BRAS. The
entered user name, password, and
authentication mode must be consistent
with those configured on the BRAS.
The default values are used. You can run
the display pots emulational
configuration command to check the
parameter values.
-
: 0/1/0
: 1
: 1
: 100
: -
: Success
10 FTTD Configuration
783