Huawei SmartAX MA5603T Configuration Manual page 386

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Item
must be the
same as the data
configuration
on the IMS.)
Procedure
l
Issue 01 (2014-04-30)
Phone number
Configure VAG1.
1. Add the upstream VLAN interface.
According to the data plan, configure standard VLAN 30 as the media and signaling
upstream VLAN, add upstream port 0/19/0 to the VLAN, and configure the IP address
of the Layer 3 interface to 10.20.10.10, which facilitates the configuration of the media
and signaling IP address pools.
huawei(config)#vlan 30 standard
huawei(config)#port vlan 30 0/19 0
huawei(config)#interface vlanif 30
huawei(config-if-vlanif30)#ip address 10.20.10.10 24
huawei(config-if-vlanif30)#quit
2. Configure the media and signaling IP address pools.
Add the IP address of the VLAN Layer 3 interface configured in the previous step to
the media and signaling IP address pools respectively. Therefore, the media and
signaling IP addresses used for the services can be selected from the IP address pools.
According to the data plan, IP address 10.20.10.10 is added to the media and signaling
IP address pools, and the gateway IP address corresponding to the media IP address
is 10.20.10.1.
huawei(config)#voip
huawei(config-voip)#ip address media 10.20.10.10 10.20.10.1
huawei(config-voip)#ip address signaling 10.20.10.10
huawei(config-voip)#quit
3. Configure a static route to the IMS.
Make sure that the route between the local device and the IMS is reachable. The static
route is used as an example.
huawei(config)#ip route-static 10.20.0.0 255.255.0.0 10.20.10.1
4. Add a SIP interface.
According to the data plan, add SIP interface 0, and configure the interface attributes.
huawei(config)#interface sip 0
Are you sure to add the SIP interface?(y/n)[n]:y
huawei(config-if-sip-0)#if-sip attribute basic media-ip 10.20.10.10
signal-ip
10.20.10.10 signal-port 5060 transfer udp primary-proxy-ip1 10.20.20.100
primary-proxy-port 5060
home-domain huawei sipprofile-index 1
5. Reset the SIP interface.
Reset the SIP interface to make the SIP interface register with the IMS (and to make
the modified attributes of the SIP interface take effect) so that the SIP interface can
work in the normal state.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Configuring the DSLAM Services
Remarks
80000000-80000031
361