Example: Configuring The Voip Service (H.248-Based And Sip-Based) - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
sippstnuser attribute set 0/2/0 priority cat2
sippstnuser auth set 0/2/0 telno 83110000 password-mode password
sippstnuser batadd 0/3/0 0/3/63 0 telno 88110000
sippstnuser attribute batset 0/3/0 0/3/63 potslinetype PayPhone
quit
Configure the polarity reversal accounting function.
pstnport
pstnport attribute batset 0/3/0 0/3/63 reverse-pole-pulse enable
quit
Save the data.
save
3.3.4 Example: Configuring the VoIP Service (H.248-based and SIP-
based)
This topic describes an example for configuring the H.248-based and SIP-based VoIP service.
The MA5600T/MA5603T/MA5608T supports the H.248-based VoIP service and the SIP-based
VoIP service at the same time.
Service Requirements
l
l
l
l
l
Figure 3-12
248 protocol.
Issue 01 (2014-04-30)
The MA5600T/MA5603T/MA5608T upstream to NGN network for ISDN service by
adopting the H.248 protocol. The MA5600T/MA5603T/MA5608T upstream to IMS
network for PSTN service by adopting the SIP protocol.
ISDN Phone A is connected to the MA5600T/MA5603T/MA5608T through the NT1, and
the ISDN digital phone supports the P2P function.
Basic rate interface (BRI) is adopted between the NT1 and the MA5600T/MA5603T/
MA5608T to provide a rate of 144 kbit/s, including two B channels and one D channel.
The Phone B and Phone C are PSTN users, the user priority is Cat2.
After the configuration is completed, normal calls can be made between two phone sets.
shows an example network of the VoIP service that based the SIP protocol and H.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Configuring the DSLAM Services
323