Huawei SmartAX MA5603T Configuration Manual page 542

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
4.
5.
6.
7.
8.
9.
10. Bind the GEM port to an ONT T-CONT.
11. Create the mapping between the GEM port and the service stream.
12. Add the service port.
Step 10 Configure the POTS service.
1.
2.
Issue 01 (2014-04-30)
l In the default GPON alarm threshold profile 1, all alarm thresholds are set to 0, which
indicates that no alarm is reported.
l In this example, the default alarm threshold profile is used. You do not need to configure
it.
Configure the GPON traffic profile.
huawei(config)#traffic table ip index 8 cir 10240 priority 0 priority-policy
tag-In-Package
Add an ONT.
NOTE
l You can add an ONT in two ways: run the ont add command to add an ONT offline or run the ont
confirm command to confirm an ONT that is in the auto-find state.
l You need to run the port ont-auto-find command in the GPON mode to enable the auto-find function
of the ONT.
huawei(config)#interface gpon 0/18
huawei(config-if-gpon-0/18)#ont add 1 0 hwhw-10101010 password-auth huawei
profile-id 2
Bind the alarm threshold profile.
huawei(config-if-gpon-0/18)#ont alarm-profile 1 0 profile-id 1
Bind the DBA profile.
huawei(config-if-gpon-0/18)#tcont bind-profile 1 0 1 profile-id 10
Divide the ONT port VLAN.
huawei(config-if-gpon-0/18)#ont port vlan 1 0 eth 10 0
huawei(config-if-gpon-0/18)#ont port native-vlan 1 0 eth 0 vlan 1510
Configure the GEM port.
huawei(config-if-gpon-0/18)#gemport add 1 gemportid 150 eth
NOTE
In the actual application, if the ONT terminal does not support the priority queue scheduling, you can use
the CAR to limit the rate when binding the GEM port to the ONT T-CONT.
huawei(config-if-gpon-0/18)#ont gemport bind 1 0 150 1 priority-queue 3
huawei(config-if-gpon-0/18)#ont gemport mapping 1 0 150 vlan 1510
huawei(config-if-gpon-0/18)#quit
huawei(config)#service-port vlan 1510 gpon 0/18/0 gemport 150 multi-service
user-vlan 10 rx-cttr 5 tx-cttr 8
Configure the upstream ports of the media stream and the signaling flow.
huawei(config)#vlan 1600 smart
huawei(config)#interface vlanif 1600
huawei(config)#port vlan 1600 0/19 0
huawei(config-if-vlanif1600)#ip address 10.176.6.33 24
Configure the static route destined to the MGC.
NOTE
When the MGC and the MG are in the same network segment, you do not need to configure the static
route.
huawei(config)#ip route-static 10.30.80.0 255.255.255.0 10.176.6.62
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 Example: Subtending Networking
517