Huawei SmartAX MA5603T Configuration Manual page 377

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Service Requirements
The service requirements are as follows:
l
l
l
l
l
Networking
Figure 3-21
Figure 3-21 Example network of the VAG service
Issue 01 (2014-04-30)
– Remote port ID
As shown in Figure 3-21, configure VAG1, and configure the users in slot 0/2 to belong
to VAG1; configure VAG2, and configure the users in slot 0/3 to belong to VAG2.
The MG communicates with the MGC through the H.248 protocol.
Configure the data plan of VAG1 as listed in
The data plan of VAG2 is the same as that of VAG1 except for the following differences:
– The media IP address and signaling IP address of VAG2 are 10.10.10.11.
– The MGC assigns phone numbers 85110000-85110031 to phones 0-31 of VAG2.
MG0 indicates VAG1 in the figure, and MG1 indicates VAG2 in the figure.
shows an example network of the VAG service.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Configuring the DSLAM Services
Table 3-15.
352