Huawei SmartAX MA5603T Configuration Manual page 540

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
4.
5.
6.
7.
8.
Step 8 Configure the SHDSL service.
The MA5600T supports the SHDSL service of multiple encapsulation modes, such as IPoA,
PPPoA, IPoE, and PPPoE. This topic uses the PPPoE mode as an example to describe how to
Issue 01 (2014-04-30)
10
> Will you set channel configuration parameters? (y/n)
[n]:y
> Please set the channel number (1~2) [1]:
1
> Channel1 configuration
parameters:
> Please set the channel-profile index (1~128) [1]:
10
Add template 10
successfully
Configure the ADSL2+ alarm profile.
The ADSL2+ alarm profile should be configured based on the actual line condition. see
"Configuring an ADSL2+ Alarm Template" for the configuration. The following uses the
alarm profile 1 as an example.
Configure the ADSL2+ traffic profile.
To configure the ADSL2+ traffic profile, run the traffic table ip command.
In this example, the default profile (profile 6) is used.
Activate the ADSL2+ port.
huawei(config)#interface adsl 0/2
huawei(config-if-adsl-0/2)#deactivate all
huawei(config-if-adsl-0/2)#alarm-config all 1
huawei(config-if-adsl-0/2)#activate all template-index 1
huawei(config-if-adsl-0/2)#quit
Configure the upstream port.
l Configure the GIU board.
By default, the GE optical port of the GIU board works in the full duplex mode with
the rate of 1000 Mbit/s.
To change the port working mode and the port rate, run the speed and duplex
command in the GIU mode.
The settings must be the same as the settings of the peer device.
l Configure the VLAN.
The ADSL2+ users of MA5600T-1 use the VLAN authentication. In this case, the
MUX VLAN is used to identify the users.
huawei(config)#vlan 1000 to 1031 mux
huawei(config)#port vlan 1000 0/19 0-1
It will take several minutes, and console may be timeout, please use
command
idle-timeout to set time
limit
Are you sure to add standard port(s)? (y/n)[n]:y
huawei(config)#port vlan 1001 to 1031 0/19 0
Add the service port.
All ports in slot 0/3 provide the ADSL2+ service. To add service ports in batches, run the
multi-service-port command.
huawei(config)#multi-service-port from-vlan 1000 port 0/2 0-31 vpi 0 vci 35
rx-cttr 6 tx-cttr 6
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 Example: Subtending Networking
515