SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
1.5.2 Checking Alarms and Events
This topic describes how to check the alarm and event reporting function of the device.
1.5.2.1 Verifying the Alarm and Event Function
This topic describes how to verify the alarm and event function by triggering various alarms and
events through the related operations.
Verifying Operation
Table 1-46
Table 1-46 Operations for verifying the alarm and event function
Operation
Remove a service board.
Insert the service board back into the
slot.
Remove the optical fiber connected to
an optical port.
Insert the optical fiber back into the
optical port.
Remove the optical fiber connected to
an optical port when an ONT is online.
Insert the optical fiber back into the
optical port.
Open the cabinet door.
Close the cabinet door.
Remove the fan tray from the shelf.
Insert the fan tray back into the shelf.
Perform the active/standby switchover
of the control boards.
1.5.2.2 Querying Alarms and Events
This topic describes how to query history alarms and events through the maintenance terminal.
Issue 01 (2014-04-30)
lists the operations for verifying the alarm and event function.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Description
Check whether the corresponding alarm or event is
generated on the maintenance terminal.
Check whether the corresponding recovery alarm or
event is generated on the maintenance terminal.
Check whether the corresponding alarm or event is
generated on the maintenance terminal.
Check whether the corresponding recovery alarm or
event is generated on the maintenance terminal.
Check whether the corresponding alarm or event is
generated on the maintenance terminal.
Check whether the corresponding recovery alarm or
event is generated on the maintenance terminal.
Check whether the corresponding alarm or event is
generated on the maintenance terminal.
Check whether the corresponding recovery alarm or
event is generated on the maintenance terminal.
Check whether the corresponding alarm or event is
generated on the maintenance terminal.
Check whether the corresponding recovery alarm or
event is generated on the maintenance terminal.
Log in to the system, and run the display event
history command to check whether the active/
standby switchover event history exists.
1 Commissioning
187