Huawei SmartAX MA5603T Configuration Manual page 958

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
l
Issue 01 (2014-04-30)
Create S-VLAN 300 with the common attribute and add upstream port 0/19/0 to the
S-VLAN.
huawei(config)#vlan 300 smart
huawei(config)#port vlan 300 0/19 0
2. Configure a traffic profile.
The 802.1p priority of the VoD service is 4, and rate limitation is not required. To
check whether any existing traffic profile meets the requirements, run the display
traffic table ip command. In this example, the query result shows that no traffic profile
meets the requirements, so a traffic profile needs to be configured.
Add traffic profile 10 and set priority-policy to local-setting. Then, traffic is scheduled
based on the priority specified in the traffic profile.
huawei(config)#traffic table ip index 10 cir off priority 4 priority-
policy local-Setting
3. Configure a service flow for the VoD service.
Configure a service flow with the GEM port ID being 14 and user-side VLAN ID
being 300. The ONU is connected to GPON port 0/2/1, upstream and downstream
traffic are rate-limited on the ONU but not on the OLT, and traffic profile 10 is
referenced.
huawei(config)#service-port vlan 300 gpon 0/2/1 ont 1 gemport 14 multi-
service user-vlan 300 rx-cttr 10 tx-cttr 10
Configure a channel for the multicast service.
1. Create an S-VLAN and add an upstream port to it.
Create S-VLAN 1000 with the common attribute and add upstream port 0/19/0 to the
S-VLAN.
huawei(config)#vlan 1000 smart
huawei(config)#port vlan 1000 0/19 0
2. Configure a service flow for the multicast service.
Configure a service flow with the GEM port ID being 14 and user-side VLAN ID
being 1000. ONT 1 is connected to GPON port 0/2/1, upstream and downstream traffic
are rate-limited on the ONU but not on the OLT, and traffic profile 10 is referenced.
huawei(config)#service-port vlan 1000 gpon 0/2/1 ont 1 gemport 14 multi-
service user-vlan 1000 rx-cttr 10 tx-cttr 10
3. Configure a multicast cascading port.
Set GPON port 0/2/1 as a multicast cascading port, ONT ID to 1, and GEM port 14
to carry the multicast service.
huawei(config)#btv
huawei(config-btv)#igmp cascade-port 0/2/1 ontid 1 gemport-index 14
4. Set the IGMP version.
Set the IGMP version to IGMPv3.
huawei(config)#multicast-vlan 1000
huawei(config-mvlan1000)#igmp version v3
5. Set the IGMP mode.
Select the IGMP proxy mode.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
11 FTTB and FTTC Solution Configuration
933