Configuring Layer 2 Interoperation Service Ports On Olt - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Procedure
Step 1 Configure the in-band management VLAN and IP address for the OLT.
Set the in-band management VLAN to 8, VLAN priority to 6, and IP address to 192.168.50.1/24.
huawei(config)#vlan 8 smart
huawei(config)#port vlan 8 0/19 0
huawei(config)#vlan priority 8 6
huawei(config)#interface vlanif 8
huawei(config-if-vlanif8)#ip address 192.168.50.1 24
huawei(config-if-vlanif8)#quit
Step 2 Configure the in-band management VLAN and IP addresses for the ONUs.
Set the static IP address to 192.168.50.2/24 for ONU1, 192.168.50.3/24 for ONU2, the gateway
IP address to 192.168.50.1, and management VLAN to 8 (which is the same as that of the OLT).
huawei(config)#interface gpon 0/3
huawei(config-if-gpon-0/3)#ont ipconfig 1 1 static ip-address 192.168.50.2 mask
255.255.255.0 gateway
192.168.50.1 vlan 8
huawei(config-if-gpon-0/3)#quit
huawei(config)#interface gpon 0/4
huawei(config-if-gpon-0/4)#ont ipconfig 1 2 static ip-address 192.168.50.3 mask
255.255.255.0 gateway
192.168.50.1 vlan 8
huawei(config-if-gpon-0/4)#quit
Step 3 Configure the in-band management service port.
Set the management VLAN to 8, GEM port ID to 11, and user VLAN to 8. The OLT does not
rate limit the in-band management service port. Therefore, directly use the default traffic profile
6.
huawei(config)#service-port vlan 8 gpon 0/3/1 ont 1 gemport 11 multi-service
user-vlan 8 rx-cttr 6 tx-cttr 6
huawei(config)#service-port vlan 8 gpon 0/4/1 ont 2 gemport 11 multi-service
user-vlan 8 rx-cttr 6 tx-cttr 6
Step 4 Confirm that the connections between the management service ports on the OLT and ONUs are
reachable.
l Run the ping ONU ip command on the OLT to verify the connectivity between the OLT and
ONUs. If the OLT receives ICMP ECHO-REPLY packets from the ONUs, the connection
is reachable.
l When the connection is reachable, you can remote log in to the ONU from the OLT and
configure the ONUs.
----End

13.3.1.5 Configuring Layer 2 Interoperation Service Ports on OLT

This topic describes how to configure service ports on the OLT for Layer 2 interoperation so
that data packets sent from different ONUs can be forwarded based on the same VLAN at Layer
2.
Prerequisites
1.
Issue 01 (2014-04-30)
The main control board on the device is an SCUN board.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
13 FTTO Configuration (Large-sized Enterprise Access)
1276