Huawei SmartAX MA5603T Configuration Manual page 957

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
l
l
Issue 01 (2014-04-30)
Create S-VLAN 100 with the stacking attribute and add upstream port 0/19/0 to the
S-VLAN.
huawei(config)#vlan 100 smart
huawei(config)#vlan attrib 100 stacking
huawei(config)#port vlan 100 0/19 0
2. Configure a traffic profile.
The 802.1p priority of the Internet access service is 0, and rate limitation is not
required. To check whether any existing traffic profile meets the requirements, run
the display traffic table ip command. In this example, the query result shows that
traffic profile 6 meets the requirements, so no traffic profile needs to be configured.
huawei(config)#display traffic table ip from-index 0
3. Configure a service flow for receiving and transparently transmitting the Internet
access service from the ONU side.
Configure a service flow with the GEM port ID being 12 and user-side VLAN ID
being 1001 (example value). The ONU is connected to GPON port 0/2/1, upstream
and downstream traffic are rate-limited on the ONU but not on the OLT, and traffic
profile 6 is referenced.
huawei(config)#service-port vlan 100 gpon 0/2/1 ont 1 gemport 12 multi-
service user-vlan 1001 tag-transform translate-and-add rx-cttr 6 tx-cttr 6
Configure a channel for the VoIP service.
1. Create an S-VLAN and add an upstream port to it.
Create S-VLAN 200 with the common attribute and add upstream port 0/19/0 to the
S-VLAN.
huawei(config)#vlan 200 smart
huawei(config)#port vlan 200 0/19 0
2. Configure a traffic profile.
The 802.1p priority of the VoIP service is 5, and rate limitation is not required. To
check whether any existing traffic profile meets the requirements, run the display
traffic table ip command. In this example, the query result shows that no traffic profile
meets the requirements, so a traffic profile needs to be configured.
Add traffic profile 9 and set priority-policy to local-setting. Then, traffic is scheduled
based on the priority specified in the traffic profile.
huawei(config)#traffic table ip index 9 cir off priority 5 priority-policy
local-setting
3. Configure a service flow for receiving and transparently transmitting the VoIP service
from the ONU side.
Configure a service flow with the GEM port ID being 13 and user-side VLAN ID
being 200. The ONU is connected to GPON port 0/2/1, upstream and downstream
traffic are rate-limited on the ONU but not on the OLT, and traffic profile 9 is
referenced.
huawei(config)#service-port vlan 200 gpon 0/2/1 ont 1 gemport 13 multi-
service user-vlan 200 rx-cttr 9 tx-cttr 9
Configure a channel for the VoD service.
1. Create an S-VLAN and add an upstream port to it.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
11 FTTB and FTTC Solution Configuration
932