Configuring E2E Reliability - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
----End

13.3.1.8 Configuring E2E Reliability

This topic describes how to configure end-to-end (E2E) protection schemes for the enterprise
private line service which has a high requirement on service reliability.
Context
Reliability covers equipment reliability, upstream networking protection, and downstream
networking protection. For details on reliability data planning, see
Reliability Data
l
l
NOTE
This topic describes how to configure five mainstream protection schemes. Select required protection schemes
based on the carrier's requirement and actual networking scenario.
Procedure
l
l
l
Issue 01 (2014-04-30)
3. Run the security anti-ipspoofing service-port serviceport-id enable command
to enable IP address anti-spoofing at the service port level.
Plan.
Upstream networking protection includes link aggregation group and protection group.
Usually, link aggregation group is configured when the GIU board is used to transmit traffic
upstream; protection group is configured when the main control board is used to transmit
traffic upstream. The two protection schemes are not configured at the same time.
Downstream networking protection includes Type B, Type C single homing, and Type C
dual homing, which are used to protect service ports. Ports on the same ONU can be
configured only with the same protection scheme.
Configure a link aggregation group.
Bind upstream ports 0/19/0 and 0/19/1 together as an aggregation link group. Each member
port in the group transmits packets based on source MAC addresses. The working mode is
LACP static aggregation.
huawei(config)#link-aggregation 0/19 0-1 ingress workmode lacp-static
Configure a protection group.
Configure upstream ports 0/19/0 and 0/19/1 on board GIU as a port protection group. Set
port 0/19/0 as the working port and port 0/19/1 as the protection port, set the working mode
to time delay detection, and enable the protection group.
huawei(config-protect)#protect-group first 0/19/0 second 0/19/1 eth workmode
timedelay enable
Configure the Type B protection.
Figure 13-2 shows the Type B protection networking diagram.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
13 FTTO Configuration (Large-sized Enterprise Access)
13.2.6 Principle of
1281