Configuring The Auto-Save And Auto-Backup Functions - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide

1.3.17.2 Configuring the Auto-save and Auto-backup Functions

This topic describes how to configure the auto-save and auto-backup functions so that data is
automatically saved in the flash memory or backed up to the server. These functions ensure that
data or configuration files are not lost after emergency restart.
Prerequisites
The file transfer mode is configured. For details, see the following descriptions.
l
l
l
NOTE
Procedure
Step 1 Configure the auto-save function and an auto-backup server.
l Configure the auto-save function
If the auto-save function is enabled, the system periodically checks whether data is modified
at the preset time or at a preset interval. If data is modified, the system automatically saves
the modified data. Otherwise, the system does not perform the auto-save operation.
Issue 01 (2014-04-30)
Backing up files starts from the host to the maintenance terminal
PARAMETERS :FrameID: 0, SlotID: 9, Position: -1, Backup type: Host data,
Backup Object: Active control board
huawei(config)#
huawei(config)#
Backing up files is successful from the host to the maintenance terminal
PARAMETERS :FrameID: 0, SlotID: 9, Position: -1, Backup type: Host data,
Backup Object: Active control board
l Assume that the IP address of the backup server is 10.10.10.1 and the configuration file
name is config0.txt. To back up the configuration file to the backup server through FTP,
do as follows:
huawei(config)#backup configuration ftp 10.10.10.1 config0.txt
Please save configuration file before backup, or the configuration
file
backuped may be not the lastest. Are you sure to continue? (y/n)[n]:
y
Load(backup,duplicate,...) begins, please wait and notice the rate of
progress
Any operation such as reboot or switchover will cause failure and
unpredictable result
Backing up files starts from the host to the maintenance terminal
PARAMETERS :FrameID: 0, SlotID: 9, Position: -1, Backup type:
Configuration
file, Backup Object: Active control board
huawei#
huawei#
Backing up files is successful from the host to the maintenance terminal
PARAMETERS :FrameID: 0, SlotID: 9, Position: -1, Backup type:
Configuration
file, Backup Object: Active control board
Configuring the FTP File Transfer Mode
Configuring the FTP File Transfer Mode
Configuring the TFTP File Transfer Mode
You need to configure only one of the above-mentioned three file transfer modes. You are advised to use
SFTP mode.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 Commissioning
131