Example: Configuring The P2P Isdn Bra Service - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
iid-map 2 pendingtime 1 cs-mode client
iua-link add 15 1 1401 10.13.4.116 1400 10.14.1.2
jointly-work-with primary-mgc priority 3
quit
esl user
mgbrauser add 0/2/0 0 1 interfaceid 8 terminalid 100 telno 12345601
quit
board add 0/3 ASP
board confirm 0/3
esl user
sippstnuser batadd 0/3/00/3/1 0 telno 83110000
sippstnuser attribute set 0/3/0 priority cat2
sippstnuser attribute set 0/3/1 priority cat2
quit
pstnport
pstnport attribute batset 0/3/0 0/3/1 reverse-pole-pulse enable
quit
save

3.3.5 Example: Configuring the P2P ISDN BRA Service

This topic describes how to configure the P2P ISDN BRA service on the MA5600T/MA5603T/
MA5608T, which is applicable to the scenario where one NT1 is connected to only one terminal.
Service Requirements
l
l
l
l
Figure 3-13
Issue 01 (2014-04-30)
ISDN Phone A is connected to the MA5600T/MA5603T/MA5608T through the NT1, and
the ISDN digital phone supports the P2P function.
ISDN Phone B is connected to the MA5600T/MA5603T/MA5608T through the NT1, and
the ISDN digital phone supports the P2P function.
Basic rate interface (BRI) is adopted between the NT1 and the MA5600T/MA5603T/
MA5608T to provide a rate of 144 kbit/s, including two B channels and one D channel.
After the configuration is completed, normal calls can be made between two phone sets.
shows an example network of the P2P ISDN BRA service.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Configuring the DSLAM Services
328