Huawei SmartAX MA5603T Configuration Manual page 339

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Procedure
Step 1 Add the upstream VLAN interface.
According to the data plan, configure standard VLAN 20 as the media and signaling upstream
VLAN, add upstream port 0/19/0 to the VLAN, and configure the IP address of the Layer 3
interface to 10.10.10.10, which facilitates the configuration of the media and signaling IP address
pools.
huawei(config)#vlan 20 standard
huawei(config)#port vlan 20 0/19 0
huawei(config)#interface vlanif 20
huawei(config-if-vlanif20)#ip address 10.10.10.10 24
huawei(config-if-vlanif20)#quit
Step 2 Configure the media and signaling IP address pools.
According to the data plan, IP address 10.10.10.10 is added to the media and signaling IP address
pools, and the gateway IP address corresponding to the media IP address is 10.10.10.1.
huawei(config)#voip
huawei(config-voip)#ip address media 10.10.10.10 10.10.10.1
huawei(config-voip)#ip address signaling 10.10.10.10
huawei(config-voip)#quit
Step 3 Add an MG interface.
Add an MG interface to communicate with the MGC, which ensures that the MGC can control
the call connection through the MG interface. According to the data plan, add MG interface 0,
and configure the interface attributes.
huawei(config)#interface mgcp 0
Are you sure to add MG interface?(y/n)[n]:y
huawei(config-if-mgcp-0)#if-mgcp attribute mgip 10.10.10.10 mgport 2727 mgcip_1
10.10.20.20 mgcport_1 2727 domainName huawei
Step 4 Configure the ringing mapping of MG interface 0.
Configure the ringing mode of the MG interface. According to the data plan, the break-make
ratios of the cadence ringing and the initial ringing are both 1:4. Therefore, the value of parameter
cadence is 0, and the value of parameter initialring is 4.
huawei(config-if-mgcp-0)#mg-ringmode add 0 0 4
Step 5 Configure the TID format of PSTN users on MG interface 0.
Configure the TID generation mode. According to the data plan, the terminal prefix of PSTN
users needs to be huawei, and the TID template adopts layering template 6.
huawei(config-if-mgcp-0)#tid-format pstn prefix huawei template 6
Step 6 Enable the MG interface.
Reset the MG interface to make the MG interface register with the MGC (or to make the attributes
of the MG interface take effect), so that the MG interface can work in the normal state.
huawei(config-if-mgcp-0)#reset
Are you sure to reset MG interface?(y/n)[n]:y
huawei(config-if-mgcp-0)#quit
Step 7 Query the running status of the MG interface.
After the MG interface is interconnected with the MGC, the MG interface should be in the normal
state, indicating that the MG interface can work in the normal state.
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Configuring the DSLAM Services
314