08/2005
3
3.5 Starting the machining at a specific point in the program
Cycle Start
Cycle Start
Reset
♥ Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl Operation/Programming ShopTurn (BAT) – 08/2005 Edition
Press the "Cycle Start" key.
ShopTurn carries out all necessary pre-settings.
Press the "Cycle Start" key again.
The new starting position is approached. The workpiece is then
machined from the beginning of the target block.
You can abort the search by pressing the "Reset" key.
Machining the Workpiece
3-101
3