Siemens SINUMERIK 840D sl Operation/Programming Manual page 346

G Code Program
7
7.1 Creating a G-code program
Edit
Measuring cycle support
Measure
turning
-or-
Calibrate
meas. cal.
...
OK
Re-
compile
Edit
Online help (PCU 50.3)
7-346
Select the "Edit" softkey if you want to return directly to the G code
editor from a parameter screen form.
Switch to the extended horizontal softkey bar.
Press the "Measure turning" or "Measure milling".
Measure
milling
Select the required measuring cycle via the softkey.
Enter the parameters.
Press the "OK" softkey.
The measuring cycle is transferred to the editor as G code.
Position the cursor on a measuring cycle in the G code editor, if
you want to display the associated parameter screen form again.
Select the "Recompile" softkey.
The parameter screen for the selected measuring cycle appears.
Select the "Edit" softkey if you want to return directly to the G code
editor from a parameter screen form.
Place the cursor on a G code command in the G code editor or on
an input field in a cycle support parameter screen form.
Press the "Help" key.
The relevant help screen is displayed.
SINUMERIK 840D sl Operation/Programming ShopTurn (BAT) – 08/2005 Edition
08/2005
7
♥ Siemens AG, 2005. All rights reserved