Siemens SINUMERIK 840D sl Operation/Programming Manual page 252

ShopTurn Functions
5
5.5 Milling
DYZ Maximum infeed in the YZ plane
Plane infeed in %: Ratio of plane infeed (mm) to milling cutter diameter (mm) – (for
roughing and finishing only)
DX Maximum depth infeed (X direction) – (for roughing and finishing only)
UYZ Finishing allowance in the plane (slot edge) – (for roughing and finishing only)
UX Finishing allowance in depth (slot base) – (for roughing and finishing only)
FS Chamfer width (inc) – (for chamfer only)
ZFS Insertion depth of tool tip (abs or inc) -- (for chamfer only)
Single position End face Y:
The reference point is always the center point of the longitudinal slot.
CP Positioning angle for machining area
X0 Reference point in X direction (abs.)
Y0 Reference point in Y direction (abs.)
L0 Reference point on longitudinal polar axis (alternative to X0)
C0 Reference point on angular polar axis (alternative to Y0)
Z0 Reference point in Z direction (abs.)
Z1 Slot depth based on Z0 (abs or inc) – (only for roughing and finishing)
DXY Maximum infeed in the XY plane
Plane infeed in %: Ratio of plane infeed (mm) to milling cutter diameter (mm) – (for
roughing and finishing only)
DZ Maximum depth infeed (Z direction) – (for roughing and finishing only)
UXY Finishing allowance in the plane (slot edge) – (for roughing and finishing only)
UZ Finishing allowance in depth (slot base) – (for roughing and finishing only)
FS Chamfer width (inc) – (for chamfer only)
ZFS Insertion depth of tool tip (abs or inc) -- (for chamfer only)
Single position Peripheral surface Y:
The reference point is always the center point of the longitudinal slot.
C0 Reference point
Y0 Reference point in Y direction (abs.)
Z0 Reference point in Z direction (abs.)
X0 Reference point (abs)
X1 Slot depth based on X0 (abs or inc) – (only for roughing and finishing)
DYZ Maximum infeed in the YZ plane
Plane infeed in %: Ratio of plane infeed (mm) to milling cutter diameter (mm) – (for
roughing and finishing only)
DX Maximum depth infeed (X direction) – (for roughing and finishing only)
UYZ Finishing allowance in the plane (slot edge) – (for roughing and finishing only)
UX Finishing allowance in depth (slot base) – (for roughing and finishing only)
FS Chamfer width (inc) (for chamfer only)
ZFS Insertion depth of tool tip (abs or inc) -- (for chamfer only)
W Slot width
L Slot length
α0
Angle of rotation of slot
Face: α0 refers to the X axis or to the position of C0 with a polar reference point
Peripheral surface: α0 refers to the Y axis
Insertion Insertion strategy
Central: Vertical insertion at center of slot
The tool executes the depth infeed vertically in the center of the slot.
Note: This setting can be used only if the cutter can cut across center.
5-252
SINUMERIK 840D sl Operation/Programming ShopTurn (BAT) – 08/2005 Edition
08/2005
5
mm
%
mm
mm
mm
mm
mm
Degrees
mm
mm
mm
Degrees
mm
mm
mm
%
mm
mm
mm
mm
mm
Degrees
mm
mm
mm
mm
mm
%
mm
mm
mm
mm
mm
mm
mm
Degrees
mm
♥ Siemens AG, 2005. All rights reserved