Siemens SINUMERIK 840D sl Operation/Programming Manual page 245

08/2005
5
Spigot
Rectangu-
lar spigot
Parameters
T, D, F, S, V See Sec. "Creating program blocks".
Position Select from 6 different positions:
Clamp/release spindle (for End face Y/Peripheral surface Y only)
The function must be set up by the machine manufacturer.
Machining
type
Chamfer
Einzelpos. Mill rectangular spigot at the programmed position (X0, Y0, Z0, L0, C0, CP).
Pos. Muster Mill several rectangular spigots in a positioning pattern (full circle or matrix).
Single position End face/End face C:
The reference point is always the center point of the rectangular spigot.
X0 Reference point in X direction (abs.)
Y0 Reference point in Y direction (abs.)
L0 Reference point on longitudinal polar axis (alternative to X0)
C0 Reference point on angular polar axis (alternative to Y0)
Z0 Reference point in Z direction (abs.)
Z1 Spigot depth based on Z0 (abs or inc) – (only for roughing and finishing)
DZ Maximum depth infeed (Z direction) – (for roughing and finishing only)
UXY Finishing allowance in depth (spigot edge) – (for roughing and finishing only)
UZ Finishing allowance in depth (spigot depth) – (for chamfer only)
FS Chamfer width (inc) (for chamfer only)
ZFS Insertion depth of tool tip (abs or inc) -- (for chamfer only)
♥ Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl Operation/Programming ShopTurn (BAT) – 08/2005 Edition
Press the "Milling", "Spigot" and "Rectangular spigot" soft keys.
>
 End face/End face C – Front
 End face/End face C – Rear
 End face Y – Front (only when Y axis exists)
 End face Y – Rear (only when Y axis exists)
 Peripheral surface Y – inner (only when Y axis exists)
 Peripheral surface Y – Rear (only when Y axis exists)
Roughing
Finishing
Description
ShopTurn Functions
5
5.5 Milling
Unit
mm
mm
mm
Degrees
mm
mm
mm
mm
mm
mm
mm
5-245